User's Manual

- 1 -

WW-MF070

LTE PCIe M.2 Module card

Signaling test User Guide

Version 0.1

Document

release

Date Modification Initials Approved

Ver. 0.1 2014/7/16

Initial version Renton Tao Ivan Chen

Ver. 0.2 2014/7/18

Add antenna gain information Renton Tao Ivan Chen

PAGE 1
WW-MF070 LTE PCIe M.2 Module card Signaling test User Guide Version 0.1 Document release Date Modification Initials Approved Ver. 0.1 2014/7/16 Initial version Renton Tao Ivan Chen Ver. 0.
PAGE 2
Step1: Select power source You can choose your power source by micro USB or 5V DC jack. Step2: Connect with host device Put in SIM card, connect antenna to base station and micro USB to your PC then you can start signaling testing. *AT commands are supported through USB interface.
PAGE 3
Federal Communications Commission (FCC) Statements: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including any interference that may cause undesired operation of the device. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC rules.
PAGE 4
Manual Information That Must be Included: The OEM integrator has to be aware not to provide information to the end user regarding how to install or remove. This RF module in the user’s manual of the end product which integrates this module. The user’s manual for OEM Integrators must include the following information in a prominent location Appendix A: Antenna Used in WW-MF070 WWAN Module FCC Tests WW-MF070 WWAN module does not have its own transmitting antenna.