User Manual

OEM Installation Info:
This device is intended only for OEM integrators under the following conditions:
1) The antenna must be installed such that 20 cm is maintained between the antenna and users,
and
2) The transmitter adapter may not be co-located with any other transmitter or antenna.
As long as 2 conditions above are met, further transmitter test will not be required.
However, the OEM integrator is still responsible for testing their end-product for any
additional compliance requirements required for the final product (for example, digital device
emissions, PC peripheral requirements, etc.).
IMPORTANT NOTE:
In the event that these conditions can not be met (for example certain laptop configurations or
co-location with another transmitter), then the FCC authorization is no longer considered
valid and the FCC ID can not be used on the final product. In these circumstances, the OEM
integrator will be responsible for re-evaluating the end product (including the transmitter) and
obtaining a separate FCC authorization.
End Product Labeling
This transmitter adapter is authorized only for use in device where the antenna may be
installed such that 20 cm may be maintained between the antenna and users (for example:
Internet Radio and Desktop PC). The final end product must be labeled in a visible area with
the following: “Contains TX FCC ID:
TLZ-GM120”.
Manual Information That Must be Included
The OEM integrator has to be aware not to provide information to the end user regarding how
to install or remove this RF adapter in the user manual of the end product which integrates
this adapter. The user’s manual for OEM integrators must include the following information
in a prominent location:
IMPORTANT NOTE: To comply with FCC RF exposure compliance requirements, the
antenna used for this transmitter must be installed to provide a separation distance of at least
20 cm from all persons and must not be collocated or operating in conjunction with any other
antenna or transmitter.