User's Manual

- 8 -
1. From the Start menu, select Run.
2. Type cmd, then click OK.
3. Navigate to the directory that contains wl.exe
4. Enter the wl ver command to check the current WL driver version.
5. Run the following command set (delay at least 700ms between each command):
11b rate:
wl mpc 0
wl phy_watchdog 0
wl country ALL
wl band b
wl channel 1
wl up
wl phy_forcecal 1
wl scansuppress 1
wl txchain
1
wl txcore -k 1 -o 1
wl 2g_rate -r
1
-b 20
wl phy_txpwrctrl 1
wl txpwr1 -1
wl txpwr1 -o -d
16
wl pkteng_start 00:11:22:33:44:55 tx
100 1024
0
This will send continuous Tx Packets with 100 us packet interval,1024 byte packet length. Data rate
=1Mbps ,Channel=1 and output power =16dBm.
11g rate: