User's Manual

- 21 -
NOTE: once the connection has been established, Inquiry and Page Scan can be disabled. Also, go to: “7.3
Host Controller & Baseband Commands” →→ “Set Event Filter”. Select “Connection Setup”; Select “Allow
Connections from all devices”; Select “Do NOT Auto accept the connection” and hit ‘OK’. This will make the
slave device non-discoverable and increase throughput by reducing overhead.
SET UP AND EXECUTE THE THROUGHPUT TEST
SET UP THE SLAVE AS THE RECEIVER
1. On the Slave side, select “Transport” and then select “Throughput Tests”. Select USB.
2. In the “Receive Test” (Bottom half of the window), fill in a data pattern such as “abcdef”, and fill in a count
such as “1000000”
3. Close the “Log Window.” If this window is left open or minimized, then the throughput test will not
achieve maximum throughput because of delay that is added by Windows every time the log window is
updated.
SET UP THE MASTER AS THE TRANSMITTER AND START THE TEST
1. On the Master side, select “Transport” and then select “Throughput Tests”. Select USB.
2. In the “Transmit Test” window (top half of the window), fill in the same data pattern and count that was
filled in for the receive test on the Slave side.
3. Close the “Log Window.” If this window is left open or minimized, then the throughput test will not
achieve maximum throughput because of delay that is added by Windows every time the log window is
updated.
4. On the Slave side, click “Execute Test” in the “Receive Test” window.
5. On the Master side, click “Execute Test” in the “Transmit Test” window.
Bluetooth throughput test is now running.
To stop the test, click “Abort Test” on the Master side first, then on the slave side.
RF Performance Test
The following procedure explains how to configure the AW-CM217NF for RF testing using Broadcom
BlueTool. At the completion
of the procedure, connect the Bluetooth test instrument to the AW-CM217NF with RF cable and performs the
RF tests.