User's Manual

- 19 -
Download Minidriver.
7. On the Transport menu, click Download Firmware/Config.
8. In Select Download Firmware/Config Transport:
a. Select USB as the type of transport.
b. In the usb port list, select usb0.
c. Click OK.
9. In Download, configure the settings to match those shown below
10. Click Execute.
11. Select the HCI protocol active check box
Throughput Test
Bluetool contains a throughput test feature that can be used with two or more AW-CM217NF devices.
Note that each device runs on a separate PC with BlueTool installed. This document will provide basic
directions for setting-up and running this test.
The next step in setting-up the test is establishing a connection between the devices.
ESTABLISH A BLUETOOTH CONNECTION BETWEEN TWO USB DEVICES
SET UP THE SLAVE DEVICE FIRST
1. On the Slave side, start Bluetool from the Start Menu.