Manual
Table Of Contents
- Use & Care Manual
 - Refrigerators Beverage Centers Wine Centers
 - Table of Contents
 - Page
 - For your safety, read all instructions carefully before operating the appliance.
 - DANGER: When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and injury to persons.
 -  Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.).
 - Save These Instructions
 - Disposal of Old Appliance
 - Dispose of your appliance packaging properly.
 - Refrigeration equipment must be properly disposed of in a way which protects the environment. This applies to your old appliance and to your new unit once it has reached the end of its service life.
 - Limited Warranty
 - Limited Warranty (continued)
 - IMPROPER USE: Azure assumes no liability for component failure or other damages resulting from improper usage or installation or failure to clean and/or maintain the product as set forth in the warranty packet provided with the product. This limited w...
 - Installation Instructions
 - Before Using Your Azure Appliance
 - Installation of Your Appliance
 - Installation Instructions (continued)
 - Built-in Cabinet Instructions
 - Installation Instructions (continued)
 - Attention
 - Check that the voltage marked on the product corresponds with your supply voltage.
 - This appliance requires a standard 115/120 Volt AC~60Hz electrical ground outlet with three pins. Have the wall outlet and circuit checked by a qualified electrician to make sure the outlet is properly grounded. When a standard two-pin wall outlet is ...
 - To prevent accidental injury, the cord should be secured behind the appliance and not left exposed or dangling.
 - Installation Instructions (continued)
 - Note: All parts removed must be saved to do the reinstallation of door
 - How to Install and Adjust the Bottom Vent
 - How to Install an Overlay Panel
 - Setting a Temperature
 - Setting the Temperature Control for your Wine Center
 - Model Numbers: A115WC-S; A115WC-O; A124WC-S; A124WC-O
 - Setting the Temperature Control for your Beverage Center and Refrigerator
 - Model Numbers: A115BEV-S; A115BEV-O; A115R-S; A115R-O; A124BEV-S; A124BEV-O; A124R-S; A124R-O
 - Key Lock
 - Shelves
 - Defrosting
 - Storage
 -  Many bottles may differ in size and dimensions. As such the actual number of bottles you may be able to store may vary.
 - Care and Maintenance
 - Cleaning Your Azure Appliance
 - Power Failure
 - Vacation Time
 - Moving Your Wine Center
 - Energy Saving Tips
 - Troubleshooting Guide
 - Parts Listing
 - A115WC-O
 - Parts Listing
 - Parts Listing
 - Parts Listing
 - Parts Listing
 - Parts Listing
 - Parts Listing
 - Parts Listing
 

13 
How to Install and Adjust the Bottom Vent 
Figure 1: The legs come packaged at their lowest height of 32.5”. You can extend these legs up to 34.5” (or your 
desired height) by unscrewing them counterclockwise. 
Figure 2: Using a Philips screwdriver, remove screw #2 and bolt #3. 
Figure 3: Loosen the remaining two screws on the top of the door bracket and make sure there is now a gap between 
the door bracket and existing vent (#5). 
Figure 4: Install the additional/extended vent (#6) from the bottom, sliding it into the gap created in Figure 3 on the 
right side of the cabinet and to the front of the existing left side vent. Set the height as you desire and then re-install 
and tighten down all bolts. 










