User manual

User Manual
Page 36 of 90
To configure the LAN groupings:
1. Select the Advanced Me
Advanced MeAdvanced Me
Advanced Menu
nunu
nu.
2. Select LAN > LAN Configuration
LAN > LAN ConfigurationLAN > LAN Configuration
LAN > LAN Configuration.
3. Select USB
USBUSB
USB in LAN group 1
LAN group 1 LAN group 1
LAN group 1 and then click < Remove
< Remove< Remove
< Remove. No packets will be sent to the
USB interface because it does not belong to any LAN group.
4. Select USB
USB USB
USB from Interfaces
Interfaces Interfaces
Interfaces and then click Add >
Add > Add >
Add > under LAN group 2
LAN group 2LAN group 2
LAN group 2. Just like in
LAN group 1, Configure
Configure Configure
Configure will appear in LAN group 2
LAN group 2 LAN group 2
LAN group 2 to allow the definition of
additional configurations.
5. To temporarily activate the settings, click Apply
ApplyApply
Apply.
6. To make changes permanent, click Save Settings
Save SettingsSave Settings
Save Settings.
Note:
Note:Note:
Note: You can configure the USB interface to a different LAN group except for the Ethernet interface,
which cannot be moved from LAN group 1.