Installation guide

KIDAtalk Hardware and Software Documentation
10
Connecting the Voice Gateway
1. Power off your network devices, including your modem and
PC.
2. If you have traditional phone service, connect the RJ-11
phone cable (included) to the Voice Gateway’s LINE port and your
telephone wall jack.
3. Connect one end of a different RJ-11 phone cable to the
Voice Gateway’s PHONE port. Connect the other end to your analog
telephone or fax machine.
IMPORTANT: Do not connect the PHONE port to a telephone
wall jack. Make sure you only connect a telephone or fax machine to
the PHONE port. Otherwise, the Voice Gateway or the telephone
wiring in your home or office may be damaged.
Voice Gateway with Router
4. Connect one end of an Ethernet network cable (included) to
the ETHERNET port of the Voice Gateway. Connect the other end to
the Ethernet port of your PC.
5. Connect one end of a different Ethernet network cable to
the INTERNET port of the Voice Gateway. Connect the other end to
your cable/DSL modem.
6. Power on the broadband modem .
7. Connect the included power adapter to the Voice Gateway’s
power port, and
then plug the power adapter into an electrical outlet. The power LED on
the
front panel will light up as soon as the Voice Gateway powers on.
8. Power on your PC.
NOTE: Make sure your PC’s Ethernet adapter is set to obtain an IP
address automatically. For more information, refer to Windows Help.
How to make a Call?
If you currently have a DECT phone at home, you will still use the same
calling pattern and style for local calls (mobile, land line). For IDD calls,
you are required to add the prefix "00"before you input the country code,
area code and number.