User manual

User Manual
Page 17 of 42
Step 2
Press Simple Connect for ten seconds from a HomePlug AV Z. After you release the
button, All LED will blink. The Power LED will stay ON.
Note: If the all LED did not blink, press Simple Connect again for ten seconds.
Step 3
Press Simple Connect Button for two seconds on the existing HomePlug AV device. After
you release the button, the Power LED will continuously blink. If the Power LED did
not blink, press Simple Connect again for two seconds.
Make sure to press Simple Connect Button again on the HomePlug AV Z within two
minutes after you press Simple Connect from the existing network.