User manual

User Manual
Page 36 of 61
The key settings for adding a new Static Route are explained:
Destination Network Address Enter the network address to which the data packets are to be
sent.
Subnet Mask Enter the subnet mask for this destination.
Use Gateway IP Address If you wish to use a specific gateway to reach the destination
network, select this checkbox and then enter the IP address of the gateway.
Use Interface If you wish to use a particular WAN interface, select the checkbox and select the
interface.
Click Save/Apply to take effect the settings.
To delete the entry from the routing table list, click its corresponding Remove button.
RIP
NOTE: RIP CANNOT BE CONFIGURED on the WAN interface that has NAT enabled (such as
PPPoE).
To activate RIP for the WAN Interface, select the desired RIP version and operation and place a check
in the 'Enabled' checkbox. To stop RIP on the WAN Interface, uncheck the 'Enabled' checkbox. Click
the 'Apply/Save' button to start/stop RIP and save the configuration.