User manual

User Manual
Page 30 of 61
Key in the following parameters:
Filter Name Key in the name of the filter rule.
Protocol Select the IP protocol to allow.
Source IP Address/Subnet Mask Enter the IP address of the remote server from which to
allow connection.
Source Port Enter the port number used by the application to allow.
Destination IP Address/Subnet Mask Enter the IP address of the PC on the LAN to which
connection is allowed.
Destination Port Enter the destination port number used by the application to allow.
Click Save/Apply to take effect the settings. The new rule will then be displayed in the Incoming
IP Filtering table list.
To delete the rule, click Remove checkbox next to the selected rule, and click Remove.