User manual

User Manual
Page 43 of 50
To create a new IP filter rule, click Add. The Add IP Filter-Incoming page will be displayed.
Key in the following parameters:
Filter Name
Filter Name Filter Name
Filter Name Key in the name of the filter rule.
Protocol
Protocol Protocol
Protocol Select the IP protocol to block.
Source IP Address/Subnet Mask
Source IP Address/Subnet Mask Source IP Address/Subnet Mask
Source IP Address/Subnet Mask Enter the IP address of the PC on the LAN to
block.
Source Port
Source Port Source Port
Source Port Enter the port number used by the application to block.
Destination IP Address/Subnet Mask
Destination IP Address/Subnet Mask Destination IP Address/Subnet Mask
Destination IP Address/Subnet Mask Enter the IP address of the remote server to
which connection should be blocked.
Destination Port
Destination Port Destination Port
Destination Port Enter the destination port number used by the application to
block.
Click Save/Apply to take effect the settings. The new rule will then be displayed
in the Outgoing IP Filtering table list.
To delete the rule, click Remove checkbox next to the selected rule, and click
Remove.