User manual

User Manual
Page 38 of 50
Route
If your LAN consists of multiple subnets and you want to manually define the data
transmitting paths, Static Route is to be used.
The key settings for adding a new Static Route are explained:
Destination Network Address
Destination Network Address Destination Network Address
Destination Network Address Enter the network address to which the data packets
are to be sent.
Subnet Mask
Subnet Mask Subnet Mask
Subnet Mask Enter the subnet mask for this destination.
Use Gateway IP Address
Use Gateway IP Address Use Gateway IP Address
Use Gateway IP Address If you wish to use a specific gateway to reach the
destination network, select this checkbox and then enter the IP address of the
gateway.
Use Interface
Use Interface Use Interface
Use Interface If you wish to use a particular WAN interface, select the checkbox
and select the interface.
Click Save/Apply to take effect the settings.
To delete the entry from the routing table list, click its corresponding Delete button.