User manual

User Manual
Page 24 of 57
Internet
The initial page will show all the settings of your existing WAN connection configured on
your router. You have an option to Add and Edit WAN interface configurations.
There are three different WAN connection methods that your router can use to connect to the
internet.
1. Mobile Broadband
2. ADSL
3. Ethernet WAN (Eth WAN)
Each connection required PVC number (0 – 8). By default, the ADSL internet connection is
PVC0 and the Ethernet WAN is on PVC7. If Eth Wan mode is not enabled, PVC7 can also be
used to configure an ADSL account. PVC1 and PVC6 are reserved for VPN lite (on ADSL
and Eth WAN respectively) if this function is enabled. If Eth WAN access is not configured,
you can use PVC0-PVC7 for different ADSL accounts. PVC8 is reserved for Mobile
broadband and is not usable for ADSL or Eth WAN.
The following describes the configuration of each of these 3 WAN connection modes.
Mobile Broadband
This access mode is to connect using the mobile broadband network. This includes
technologies such as 3G and LTE. In order to use this mode, you will need one of the
supported Mobile Broadband dongles. A up-to-date list of the currently supported dongles is
available for download from www.telkomphones.co.za
Once you have places a SIM card into your supported dongle, you can plug it into either of
the USB sockets on the rear of the router. The router is set to automatically configure the
connection with the network supplied configuration. You will be able to see this
configuration if you click on the Mobile Broadband radio button.