User guide

ADSL2+ 4-Port Ethernet USB Wireless-G Router - User Guide
Page 53 of 87
Ingress Layer 2 Priority Bits to CoS Configuration
1. From Interface drop-down box, select quickstart.
You are configuring QoS on this WAN interface.
2. Select CoS1 in Class of Service and 5 in Priority Bits.
Any packets with priority marking 5 is mapped to CoS1, the highest priority that is
normally given to the voice packets.
3. Click Apply to temporarily activate the settings.
4. Select CoS2 in the Class of Service field and 1 in the Priority Bits field. Any packets that
have a priority bits of 1 is mapped to CoS2, which is the second highest priority. This is
given to the high priority packets such as video.
5. Click Apply to temporarily activate the settings.
Note—The changes take effect when you click Apply; however, if the router configuration
is not saved, these changes will be lost upon reboot.
6. Repeat step 2-5 to add more rules to quickstart.
Up to eight rules can be configured for each interface.
Note—Any priority bits that have not been mapped to a CoS default to CoS6, the lowest
priority.
7. Repeat step 1-6 to create rules to another WAN interface.
Note—Any WAN interface that is not configured has the default Untrusted mode.