Installation guide
Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 90
The URL text field requires the complete request to be sent to the DynDNS server. Normally it has the format:
[http://]www.server.domain:port/scriptpath/scriptname?param1=value1¶m2=value2
The request modifies the nameserver database so that the hostname will be resolved to the new IP address.
The Basic Authentication checkbox enables the encoding of the username and password entered in the text fields above, and then uses the Basic
Authentication method to notify the provider about the user authentication settings.
Most of the DynDNS providers require an authentication for security. The user can do that either together with the HTTP get request in the text field
URL or by selecting the Basic Authentication checkbox.
ATM Statistics
This page is available only when ADSL or G.SHDSL interface is available on the Quadro. It provides statistics information for traffic on the ADSL or
G.SHDSL interface. ATM Statistics page consists of two pages: General (with general information about the link) and ADSL or G.SHDSL (for
interface specific statistics) depending on the active interface.
In its turn, General page consists of following sub-pages:
Common page indicates information about the link/connection
status (UP or DOWN) and the TX and RX bandwidths (in kbits).
Fig. II-145: ATM Statistics – General – Common page
Link Event page indicates the information about the link events.
Last event field indicates the seconds since the last status
change.
Status change field indicates the number of status changes.
Bandwidth change field indicates the number of bandwidth
changes.
Fig. II-146: ATM Statistics – General – Link Events page
AAL counters page indicates ATM cell counters ordered by the
traffic type. Each of the following counters are presented for all,
AAL0 (raw ATM cells), AAL2 (voice over ATM specific traffic
type) and AAL5 (general data traffic (RFC1483R/B, PPPoA,
PPPoE)):
TX cells - cells transmitted (upstream);
TX error - cells with transmission errors;
RX cells - cells received (downstream);
RX error - cells received with errors;
RX drop - received cells dropped due to a lack of local
resources.
Fig. II-147: ATM Statistics – General – AAL Counters page