Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 9
Internet Configuration Wizard
The Internet Configuration Wizard is the helpful tool for the administrator to configure the WAN interface settings and to adjust Quadro’s
connectivity with an external network. The Internet Configuration Wizard MUST be run if it is desired for Quadro to be connected to the
Internet.
All the settings of the Internet Configuration Wizard are
described in the chapters below except those for the IP settings,
which will be described in this chapter.
Please Note: It is strongly recommended to leave the factory
default settings if their meanings are not fully clear to the
administrating person.
Fig. II-7: Internet Configuration Wizard - Start page
The Wizard allows navigating through the following basic configuration parameters and settings:
• Uplink configuration (see below)
For WAN Interface protocol PPPoE, PPPoA,
1483B and 1483R:
• PPP/ PPTP Settings
• WAN Interface Configuration (see below)
• DNS Settings
For WAN Interface protocol PPTP:
• WAN IP Configuration (see below)
• PPP/ PPTP Settings
• WAN Interface Configuration (see below)
• DNS Settings
For WAN Interface protocol Ethernet:
• WAN IP Configuration
• WAN Interface Configuration (see below)
• DNS Settings
The Switch to Auto Provisioning link moves you to the
Automatic Provisioning page where Quadro can be configured by the automatically
provisioning mechanism.
The Uplink Configuration page allows to select the Quadro‘s WAN
interface connection type and its bandwidth settings. These settings
make Quadro available to the external network.
Depending on the Uplink Interface Protocol selection, the page
following the Uplink Configuration page is different. Thus if
PPPoE is selected, the next page will be PPP Configuration, while
selecting Ethernet will bring up the WAN IP Configuration page.
The Uplink Configuration page offers the following components:
The WAN Interface Protocol radio buttons are used to choose the
protocol depending on the requirements of the ISP (Internet Service
Provider):
PPPoE - turns on the PPP over Ethernet connection type.
PPPoA – selection is only available when corresponding
interfaces are present on the Quadro and are used to turn on
the PPP over ADSL/G.SHDSL connection type.
1483B and 1483R – selections are only available when
corresponding interfaces are present on the Quadro and
represent variations of DSL/PPPoA used by certain providers.
PPTP – turns on the Point to Point Tunneling Protocol (PPTP)
interface used for the connection between Quadro and ADSL
modem. Fixed IP address configuration is needed in this case.
Ethernet - turns on the Ethernet connection type.
Fig. II-8: Internet Configuration Wizard - Uplink Configuration page
The WAN Interface Bandwidth settings allow the specification of the upstream and downstream speeds in kbit/s, helping to assure the quality of IP
calls. An IP call looses the voice quality if there will be no available bandwidth. In case of reaching the borders of bandwidth, another IP call will be
declined.