Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 75
VoIP Carrier Wizard – Page 3 contains VoIP Carrier access
code selection components:
Access Code text field requires a digit combination by dialing
which the corresponding VoIP Carrier will be reached.
Route Incoming Calls To drop down list allows to select an
extension (or Auto Attendant) on the Quadro where incoming
calls from the configured VoIP Carrier should be routed to.
Failover to PSTN checkbox selection will route the call to
PSTN through local FXO line in case if VoIP Carrier is not
available. When this checkbox is selected, an additional entry
will be added to the
Call Routing table maintaining digit
transmission to local PSTN when IP call towards the
configured VoIP Carrier cannot be established.
Please Note: Warning message will inform that the defined
Access Code already exists in the Call Routing table or
causes a conflict with entries already in the Call Routing table.
In this case, when proceeding the VoIP Carrier Wizard,
existing entry in the Call Routing table will be automatically
overwritten by the new settings.