Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 74
VoIP Carrier Wizard – Page 2 is used to define VoIP Carrier
Settings. Page contains following components:
1. VoIP Carrier Common Settings
Account Name text field requires a username for
authentication on the defined SIP server.
Password requires a password for authentication on the
defined SIP server.
Confirm Password requires a password confirmation. If the
input is not corresponding to the one in the Extension
Password field, the error will appear: “Incorrect Password
confirm”.
SIP Server text field requires an IP address or the hostname
of the SIP server destination party is registered on.
SIP Server Port text field requires the port number of the SIP
server destination party is registered on.
2. VoIP Carrier Advanced Settings
Use RTP Proxy checkbox is applicable only when route is used for calls towards configured VoIP Carrier from peer located outside the Quadro.
When this checkbox is selected, RTP streams between external users will be routed through Quadro, otherwise, when checkbox is not selected,
RTP packets will be moving directly between peers.
UserID requires an identification parameter to reach the SIP server. It should have been provided by the SIP service provider and can be requested
for some SIP servers only, for others, the field should be left empty.
Send Keep-alive Messages to Proxy enables the SIP registration server accessibility verification mechanism. Timeout indicates the timeout
between two attempts of SIP registration server accessibility verification. If no reply is received from the primary SIP server within this timeout, the
secondary SIP server will be contacted. When the primary SIP server recovers, SIP packets will be sent to it once again.
A group of Host address and Port text fields respectively require the host address (IP address or the host name), the port number of the Outbound
Proxy, Secondary SIP Server and the Outbound Proxy for the Secondary SIP Server. These settings are provided by the SIP servers’ providers
and are used by Quadro to reach the selected SIP servers.