Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 7
Administrator’s Menus
System Menu
Fig. II-1: System Menu in Dynamo theme Fig. II-2: System Menu in Plain theme
System Configuration Wizard
The System Configuration Wizard is the helpful tool for the administrator to define the Quadro’s Local Area Network settings and to specify
regional configuration settings to make Quadro operational in its LAN. The System Configuration Wizard MUST be run upon Quadro's first
startup to make sure that it works properly in its network environment. The Wizard allows navigating through the following basic configuration
parameters and settings:
• System Configuration (see below)
• DHCP Settings for the LAN Interface
• Regional Settings and Preferences (see below)
• Emergency Codes and PSTN Access Codes Settings (see below)
DHCP Settings for LAN are described in the chapters below
while LAN configuration and regional settings will be described
in the current chapter.
Please Note: It is strongly recommended to leave the
factory default settings if their meanings are not fully clear
to the administrating person.
Fig. II-3: System Configuration Wizard - Start page