Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 56
Other enables the MAC address text fields used to insert the
MAC Address of the corresponding SIP phone.
• Line Appearance text field requires number of simultaneous
calls supported by the SIP phone.
• Username and Password are required for this selection,
which should match on both the Quadro and the SIP Phone
for successful connection establishment.
Fig. II-98: IP Line Edit page
Supported SIP Phones
Below is the list of SIP phones that can be automatically configured to work with Quadro2x/4x/16x:
• Snom 190, Snom 200, Snom 220, Snom 320, and Snom 360
• Polycom Soundpoint IP 300SIP
• Cisco IP Phone 7960
• Swissvoice IP 10S
• IP Dialog SIP Tone II (ST201)
• Aastra 480i
• Sipura SPA-841 IP
Loopback Settings
The FXS Lines Loopback Settings page is used to configure the lines for voice loopback diagnostics. When loopback is enabled on the line, any
incoming calls to the corresponding line will be automatically picked up on the first ring and any voice towards the line will be automatically sent back
to the caller, i.e., caller will hear themselves in the handset. Loopback Timeout gives a possibility to limit the voice loopback diagnostics duration,
i.e., caller will be disconnected from the Quadro when the Loopback Timeout expires.
The FXS Lines Loopback Settings page shows the only table where all FXS lines of the Quadro are listed. Here, loopback diagnostics may be
enabled/disabled and the Loopback Timeout can be adjusted for FXS lines.
The FXS Lines Loopback table lists all the FXS lines on the Quadro
along with their loopback parameters (Loopback State and Loopback
Timeout).
The Edit functional link leads to the FXS Lines Loopback Settings -
Edit Entry page where Loopback Timeout (in seconds) may be
configured for one or more selected FXS line(s).
The Enable/Disable Loopback functional link is used to enable/disable
the Loopback service on the selected FXS line(s).
Fig. II-99: IP Line Settings –Loopback page