Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 54
The page Onboard Line Settings shows the table Available
Lines where all active lines of Quadro are listed with their
Attached Extension (if attached, else none). Further, the table
provides information about the selected Ringer Type and Caller
ID detection method that is configured for the selected line. The
caller ID detection method is different for various types of phones
and can be found in the phone manual.
The Loopback Settings link takes you to the page where lines
can be configured for loopback diagnostics purposes.
Fig. II-95: Line Settings Page
When pressing on the line number under the Available Lines column
, the Onboard Line Settings page specific for the current line is opened and
offers the following input options:
Caller ID drop down list contains various standards of Caller ID
transmission used to send the calling party's information to the
phone attached to the selected line:
• No Caller ID.
• FSK, send prior to the first ring.
• FSK, send between the first and second ring.
• FSK, send both prior to ring and between the first and second
ring.
• DTMF, send prior to the first ring.
• DTMF, send between the first and the second ring.
• Combined, send both DTMF prior to the first ring and FSK
between the first and the second rings.
The Quadro sends the current time/date to the called phone
together with the caller’s information.
Fig. II-96: Line Codec and Caller ID Settings page
A group of Remote Party Disconnect Indication parameters are used especially to configure the private PBX attached to the Quadro FXS port.
• The Enable Busy Tone Indication checkbox enables the busy tone transmission to the FXS port when the remote party being in call is
disconnected. The Busy Tone Duration drop down list is used to select the period (in seconds) when a busy tone will be transmitted to the
FXS port.
• The Enable Power Disconnect Indication checkbox enables the power cycling on the FXS line when the remote party being in call is
disconnected. Power Disconnect is applied after the busy tone transmission on the FXS line. The Disconnect Duration drop down list is
used to select the period (in milliseconds) when the FXS line power will be down.
The Ringer Type drop down list allows to select the frequency of the ringer supported by the phone attached to the line. Information can be found on
the phone enclosure or in the phone's manual. Problems with the ringer might occur if the ringer type selected here does not correspond to the one
supported by the phone.
Please Note: The supported ringer type can be found on the phone bottom, in the “Ren:x.xN” value where N is the ringer type supported by the
phone, (e.g., if N=A, the TypeA ringer type should be selected, if N=B, the TypeB&Z ringer type should be selected).