Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 53
The Add Entry page includes the following text fields:
Add opens the Add Entry page where a new IP range
can be added.
Edit opens the Edit Entry page where the IP range can
be modified. The page includes the same components as
the Add Entry page.
The NAT Exclusion Table lists all possible IP ranges that
are not included into the NAT process, but may be
accessed directly. IP addresses that are not listed in the
NAT Exclusion Table are accessed over NAT.
Fig. II-93: NAT Exclusion Table page
IP address requires the IP address that is placed behind
NAT within the local network.
Subnet Mask requires the subnet mask corresponding to
the specified IP address.
Fig. II-94: NAT Exclusion Table - Add Entry page
To Configure the NAT Exclusion Table
1. Press the Add button on the NAT Exclusion Table page. The Add Entry page will appear in the browser window.
2. Specify an IP Address and its Subnet Mask in the corresponding text fields.
3. Press Save on the Add Entry page to add the selected IP range to the NAT Exclusion Table list.
To Delete an IP Range from the NAT Exclusion Table
1. Select the checkboxes of the corresponding IP range(s) that ought to be deleted from the NAT Exclusion Table. Press Select all if all IP
ranges ought to be deleted.
2. Press the Delete button on the NAT Exclusion Table page.
3. Confirm the deletion with Yes. The IP range will be deleted. To abort the deletion and keep the IP range in the list, press No.
Line Settings
The Line Settings are used to configure Quadro FXS and IP Line (if available on the board) settings. The Line Settings page consists of two pages:
Onboard Line Settings page for onboard FXS lines configuration and IP Line Settings for IP Lines configuration.
Onboard Line Settings
The Onboard Line Settings page is used to configure Quadro lines and to define the caller ID detection type, configure remote party disconnect
indication and select the ringer type on each of them. Additionally this page provides a possibility to enable Loopback diagnostics on the lines.