Installation guide

Quadro Manual II: Administrator's Guide Quadro's Graphical Interface
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 5
Quadro’s Graphical Interface
Administrator’s Main Page
As the result of logging in as an administrator, the page Quadro Management is displayed with a table of active calls (including information about
call peers, call duration and start time) at the startup. Here the administrator may access the following settings and perform the actions:
Fig. II-1: Quadro4x Management
System Menu
• System Configuration Wizard
• Internet Configuration Wizard
• Status
• IP Routing Configuration
• Configuration Management
• Events
• Time/Date Settings
• Mail Settings
• SMS Settings
• Firmware Update
• Networking Tools
• Diagnostics
• Automatic Provisioning
• Features
• Upload Language Pack
• User Rights Management
Telephony Menu
• Call Statistics
• SIP Settings
• RTP Settings
• NAT Traversal Settings
• Line Settings
• FXO Settings
• ISDN Settings
• Gain Control
• Call Routing
• VoIP Carrier Wizard
• RADIUS Client Settings
• Voice Mail Common Settings
• Dial Plan Settings
Internet Uplink Menu
• PPP/ PPTP Settings
• VPN Configuration
• Dynamic DNS Settings
• ATM Statistics
• Firewall and NAT
• Filtering Rules
• IDS Log
Users Menu
• Extensions Management
• Receptionist Management
•
• Extensions Directory
LAN Services Menu
• DNS Settings
• DHCP Settings for the LAN
Interface
Registration Form
(in menu tree only)
2Logout
The functional button Renew Wan IP Address appears on the administrator’s main Quadro Management page if the Quadro device acts as a
DHCP client. The Renew WAN IP Address button is used to get a new WAN IP address in case, e.g., the Quadro moves to another network.
The functional button Establish Your Internet Connection Now respectively Terminate Your Internet Connection Now occurs on the Quadro
Management page if PPPoE is used as WAN interface protocol.
The link Please Check Your Pending Events will be displayed on the administrator Main Menu page if new system events exist. The link leads to
the Events page that can be also accessed from the System menu.
The list of Users currently logged into the system is seen in the lower right corner of the Administrator's Main Menu. Information about IP address
user accessed Quadro GUI from, the username user is logged in and the time until the next automatically logout is provided herein. The idle session
timeout is set to 20 minutes. If no action is performed during that time, user will be automatically moved to the Login page and will be requested to
login again.
The link Refresh in occurs in the upper right corner beside the field displaying the number of seconds until the next refresh and is used to perform a
manual reload of the page. If a page with a Refresh counter is left opened, the session time-out counter will be updated periodically and the logout
timeout will never expire.