Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 29
• Administrator – this is a main (super) administrator’s account. It is a matter of configuration whether to have password factory reset safe
or not, i.e. whether default password will be retrieved after the factory reset or not. Administrator has an access to all Web GUI pages, no
configuration permissions can be adjusted for this account. Administrator is responsible for granting access to all other user groups.
• Local Administrator – this is a common (sub-) administrator’s account. Password is not factory reset safe. Local Administrator’s
permissions can be adjusted per each GUI page.
• Extension – account refers to all extensions created on the Quadro. The password for default extensions is not factory reset safe but is
contained in the backed up configuration. Extension’s permissions can be adjusted per each GUI page.
User Rights Management page consists of two pages: Users, no manage the available users on the Quadro, and Roles, to assign the
corresponding permissions to the users.
Users page contains a table where Administrator and Local
Administrator users are listed. Page allows to modify the
passwords of available users in the table and to manage the
Local Administrator’s account. Following functional buttons
are available on the page:
Change Password functional button is used to change the
password of the Administrator and Local Administrator user’s
account. Select one of the available users in the table by
toggling the corresponding checkbox and press Change
Password to open the corresponding page.
Fig. II-48: Users page at User Rights Management
The Change Password page is used to change the user’s
password. It offers the following components:
Old Password text field is only present when modifying the
Administrator account password and requires the current
password of Administrator. An error message prevents
from entering a wrong one.
New Password requires the new password for
Administrator or Local Administrator, which has to be
confirmed in Confirm New Password.
The password may consist of numerical values only, up to
20 digits are allowed. A corresponding warning appears if
any other symbols are inserted.
Store password in persistent area (Factory reset save)
checkbox is only present when modifying the Administrator
account password and is used to save the Administrator’s
in the factory reset safe place.
Attention: Be EXTREMELY careful when enabling this
checkbox – if it is done, Administrator’s password won’t be
retrieved even after factory reset. In this case, if
Administrator’s password has been forgotten, the Quadro
will be considered as broken. Please contact Epygi
Technical Support Center for device replacing.
Fig. II-49: Change Password page
Enable User and Disabled User functional buttons are used to enable/disable the Local Administrator’s account.
Please Note: Administrator’s account cannot be disabled.
Roles page contains a table where Local Administrator and
Extensions users are listed. Page allows to set the permissions to
the GUI pages for each user in the table.
Edit functional button leads to a Change Access Rights page
where a list of user specific GUI pages is displayed. Select on of
the users in the table and press Edit to manage the permission for
the corresponding user.
Fig. II-50: Roles page at User Rights Management