Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 27
Diagnostics
The System Diagnostic page gives a possibility to run Network and WAN protocol diagnostics, to verify Quadro's connectivity and to download all
system logs for possible problems recovery.
The Start Detecting WAN Protocol button is used to initiate WAN diagnostics that will detect the WAN IP configuration: static or through DHCP and
PPP servers. For static WAN IP configuration, gateway availability is checked. When acting as a client, DHCP and PPP servers' accessibilities are
being verified.
The Start Network Diagnostics button is used to initiate network
diagnostics, i.e., to check the WAN link and IP configuration, to
verify gateway, DNS primary and secondary (if configured) servers'
accessibilities.
The Start ISDN Diagnostics button is used to initiate ISDN BRI
low level diagnostic. With these tests ISDN physical link is checked
and Frame Synchronization is verified.
The field below will display the diagnostics results and the
connectivity conditions. The system should be reconfigured if
problems occur during the diagnostics.
The Download system logs button is used to download all logs to
the local PC as a *.tar archive file. These logs can then be used by
the Epygi Technical Support Office to determine the problem that
had occurred on your Quadro.
The Reboot this Device button is used to reboot the Quadro.
Please note that the session with the Quadro will be closed, i.e.,
the Quadro GUI should be newly opened and a new login will be
required afterward.
Fig. II-43: System Diagnostic page
Automatic Provisioning
Automatic Provisioning gives a possibility to automatically
configure the WAN network settings of Quadro. This is very useful,
when the administrator is not actually aware about the Quadro’s
network settings. Automatic Provisioning automatically detects
the matching network configuration settings and by applying them
on the Quadro, it connects the device to the internet through the
available ISP connection.
Please Note: Automatic Provisioning can be run only from the
LAN side of the Quadro, i.e. from the PC connected to the
Quadro’s LAN.
Automatic Provisioning automatically detects and configures the
following settings on the Quadro:
• WAN interface type (PPPoE or Ethernet)
• WAN IP settings
• PPP settings
• ISP settings
• DHCP settings
• DNS settings
• NAT Traversal settings
Fig. II-44: Auto Provisioning page