Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 25
server via HTTPS. Checkbox selection enables a Secure
Port text field that requires the port number for HTTPS
traffic.
Send Test Mail is used to send a test SMS to the defined SMS Recipient Address. This button will be enabled if correct values have been submitted
and saved on this page.
Firmware Update
This window allows to update the software of Quadro by installing new firmware called image. Users registered at Epygi will receive a notice when
new firmware is available and will be able to download it from the Epygi Technical Support WEB page.
Updating a new firmware requires a perfectly working power supply. Therefore Quadro is provided with a battery (accumulator). If the battery is low
or simply absent the “There is no battery or voltage is low” warning is displayed
Please Note: Installing new firmware will take about 15
minutes. During this time, the QuadroCS, telephony and
Internet access will be disabled.
The firmware update will cause the loss of the following data:
• All internally stored voice mails and custom voice messages
• DHCP leases
• Transfer statistics
• Call statistics
• All pending events
• User specific GUI states
The following main processes will be stopped during the
firmware update and will be restarted afterwards:
• Voice Software
• Network Time Protocol Daemon
• Network Interface Statistic Daemon
• Dynamic DNS Daemon
Please Note: If you consider the
Call Statistics entries in the
displayed tables to be important, it is recommended to
download them from the corresponding page prior to starting
the Firmware Update.
Next will move you to the second page of Firmware Update
where the image file should be selected.
Fig. II-39: Firmware Update page 1
The second page of Firmware update has the Browse button
used to browse the image file, and the Specify Image text field
that will display the selected image filename.
Pressing Save will start uploading the image file to the board.
The next page will be displayed, showing the result of a
verification of the image being burned.
Fig. II-40: Firmware Update page 2