Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 24
Attention: Time and Date Settings will be reset if Quadro has lost power.
Mail Settings
The System Mail Settings page gives a possibility to send warnings automatically about the board status or problems to the administrator. System
events that require email notification are selected on the
Events page. Besides, system mail has to be enabled and the SMTP server needs to be
configured for voice message transmission to the extension user’s mailing account.
Enable enables the system mail sending possibility and voice
messages transmission to the extension user’s mailbox.
SMTP Host requires the SMTP host IP address or domain
name. The SMTP host needs to be configured to enable voice
message transmission.
Mail Sender Address requires the source address for the
Quadro notification emails. The email address defined here
should be an existing valid email address registered on the
selected SMTP server or should have permission to use that
particular SMTP server for emails transmission.
Mail Recipient Address requires an active email address. The
e-mail recipient here can be a Quadro administrator or someone
responsible for network and system problems.
Enable SMTP Authentication has to be selected if the
specified SMTP server requires an authentication. In this case,
authentication User Name and Password configured on the
SMTP server should be defined in the corresponding text fields.
Send Test Mail is used to initiate a test e-mail transmission.
This button will be enabled if correct values have been
submitted and saved on this page.
Fig. II-37: System Mail Settings page
To configure the System Mail
1. Enable the system mail sending by the Enable checkbox selection.
2. Update or set the SMTP host in the SMTP Host text field.
3. Update or set the e-mail sender address in the Mail Sender Address text field.
4. Update or set the e-mail address in the Mail Recipient Address text field.
5. Enable SMTP Authentication if it is required of the server.
6. Insert into the corresponding text fields an authentication User Name and a User Password defined by your SMTP server.
7. Press the Save button to submit these settings.
8. Use the Send Test Mail button to send a test e-mail with the configured settings.
SMS Settings
The SMS Settings are used to configure the SMS parameters that will allow Quadro to send the voice mail notifications via SMS to the extension
user’s mobile phone. Every extension user is free to enable the voice mail notifications upon new voice mail arrival and to define own mobile
numbers from the Voice Mail Settings. However, to make Quadro able to deliver SMS notifications, SMS service should be enabled and SMS
settings should be configured from this page.
Enable SMS Service enables the SMS service on the Quadro.
User Name and Password text fields require the authentication
settings of the SMS server.
SMS Sender Address requires the source address for the
Quadro notification SMS. The address defined in this field will
be seen in the “From” field of the SMS delivered to the mobile
phone.
SMS Recipient Address requires a destination mobile number
for a test SMS.
HTTP Parameters:
ID text field requires an identification number defined by
the SMS server.
Server text field requires an IP address or the host name
of the SMS server.
Port text field requires a HTTP port number of the SMS
server.
Use Secure HTTP checkbox enables access to SMS
Fig. II-38: SMS Settings page