Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 13
The area Receive Values:
• Receive Bytes - number of received bytes
• Receive Packets - number of received Ethernet
packets
• Receive Errors - number of received packets
containing errors
• Receive Drop Errors - number of received packets that
have been discarded
• Receive Overrun Errors - number of received overrun
errors that occur when the receive buffer is not large
enough to hold all incoming packets. This error mostly
appears because of a slow receiving system.
• Receive MultiCast Packets - number of received
broadcast packets
The area Transmit Values:
• Transmit Bytes - number of transmitted bytes
• Transmit Packets - number of transmitted Ethernet
packets
• Transmit Errors - number of transmitted packets
containing errors
• Transmit Drop Errors - number of transmitted packets
that have been discarded
• Transmit Carrier Errors - number of transmit carrier
errors that occur because of a defective or lost
connection on the Ethernet link
• Transmit Collisions - number of transfer errors that
occurred during a simultaneous packet transmission
from both sides
Fig. II-14: Transfer Statistics Diagram Chart
To show the Transfer Statistics Diagram Charts, select the desired criteria and click Save to generate the corresponding chart and the table with
transfer statistics values (if enabled). The letters M and K used in the legend of the displayed diagrams show the total number of specified criteria: K
means thousands and M millions. Reset Statistics button is used to reset the chart and the table (if enabled).
Lines Status
The page Quadro Status - Lines Status shows the current status of each of the FXS, IP and FXO lines with all details of the attached extension.
Since only one line of information can be displayed at a time, the Line, IP Line and FXO functional buttons are used to navigate through the other
lines’ information.
The Lines Status table displayed for FXS and IP lines include a group of static and dynamic parameters. Static parameters are displayed, always,
while dynamic parameters only appear whenever an event takes place on the extension.