Installation guide

Quadro Manual II: Administrator's Guide Administrator's Menus
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 12
Network Status
The Network Status page includes the following information
about Interfaces:
Interface Name lists the Network interfaces available on the
Quadro (LAN, WAN, IPSec and a number of PPPs, depending on
the number of active PPP connections).
IP Address lists the IP addresses corresponding to each network
interface.
Subnet Mask lists the subnet masks corresponding to each
network interface.
Properties lists either the MAC address corresponding to each
network interface on the Quadro or PPTP, L2TP and IPSec peer
IP address if an active VPN (IPSec or PPP) interface exists.
Monitor includes links to survey LAN, WAN, IPSec and PPP
traffic correspondingly. The VPN traffic link will be displayed only if
a VPN has been configured. The selection of these links will open
a new window with a table of network traffic statistics on the
selected interface:
• Received Bytes
• Received Packets
• Received Errors
• Received Drop Errors
• Received Overrun Errors
• Received MultiCast Packets
• Transmitted Bytes
• Transmitted Packets
• Transmitted Errors
• Transmitted Drop Errors
• Transmitted Carrier Errors
• Transmitted Collisions
Fig. II-12: Quadro Status Network Status page
When opening the corresponding interface statistics window, no traffic values are displayed at first. Then every one minute, traffic statistics will be
updated. The tables serve as a kind of counter.
DNS Server, Alternative DNS Server and Default Gateway - displays the Quadro settings corresponding to what has been configured with the
System Configuration Wizard.
Services (NTP Server and Client, DHCP Server and Client, DNS, Firewall, NAT, PPP, IDS) statuses: stopped or running.
View VPN Status link refers to the
VPN Configuration page where all VPN (IPSec, PPTP and L2TP) connections can be viewed and edited.
Transfer Statistics - link to the Transfer Statistics page.
The Transfer Statistics page allows a user-defined statistic
table depending on the transmit/receive value (criteria),
interface type and time period. It contains the following
components:
Time Range of statistic table - the drop down list includes
the period(in days) statistics data is to be collected and the
corresponding diagram charts are to be built.
Interface - the drop-down list offer the values:
• WAN - Wide Area Network (WAN) events only
• LAN - Local Area Network (LAN) events only
When Show also as readable values checkbox is selected,
an additional table with statistics values will be displayed on
the next page.
Fig. II-13: Transfer Statistics page