Installation guide

Quadro Manual II: Administrator's Guide System Default Values
Quadro4x, 4xi, 4xa, 4xia, 4xs, 4xis, Quadro16x, 16xi, 16xa, 16xia, 16xs, 16xis; (SW Version 3.1.x) 106
Parameter System Default Value
T309 timer – 0,
T310 timer – 60000,
After Guard Timeout -150,
Switch type - basic_dss1,
Channel Selection – preferred,
Bearer Establishment Procedure - on call acceptance,
Called Party Type of Number – unknown,
Calling Party Type of Number – unknown,
Called Party Numbering Plan – ISDN/telephony numbering plan,
Calling Party Numbering Plan – ISDN/telephony numbering plan,
Incoming Called Digits Size – 0,
Generate Progress Tone to IP – disabled,
Enable CLIR Service – disabled,
Alternative Disconnection Mode – enabled,
B1 and B2 channels – enabled.
Gain Control Settings
FXS lines:
Transmit Gain: - 6
Receive Gain: 0
FXO lines:
Transmit Gain: 0
Receive Gain: 6
ISDN Trunks:
Transmit Gain: 0
Receive Gain: 0
Call Routing
Route all incoming SIP calls to Call Routing - disabled
Local Routing table - 6 entries for FXO Quadros and 4 entries for ISDN Quadros.
Entries are defined for IP, PBX and PSTN calls establishment.
Local AAA Table - no entries.
RADIUS Settings
RADIUS client - disabled
Voice Mail Common Settings
Voice Mail Recording - G729a
Memory Allocation - Embedded Memory Storage
Dial Timeouts 4 seconds
IPSec, PPTP and L2TP No connections
Dynamic DNS Disabled
Firewall
Enabled, Medium level,
Ping Stealth - enabled
Fool Portscanner - disabled
IDS Enabled
NAT Enabled
Filtering Rules
Outgoing Traffic - MS File Sharing
(Blocked for all),
SIP Access (Allowed for all),
No user defined services and IP pool groups