User's Manual

User Manual
Page 7 of 43
Access
Point
LED should be
OFF while
WL559E is
booting up.
LED should be OFF
while WL559E is
booting up.
LED should be OFF
when AP is
completely boot up
LED should be ON
when AP is fully boot
up
LED should be
ON after fully
boot up
LED should be ON
after f
fully boot up
LED will blink 2x
once
authentication with
the WPS is
successful
LED will be blinking if
not connected to a
router
LED should be
OFF while
WL559E is doing
WPS
authentication.
LED should be OFF
while WL559E is
doing WPS
authentication.
LED will blink for 2
minutes when WPS
button is pressed.
Wireless
BRIDGE
LED should be
ON if WL559E is
connected to
Router and RSSI
value is equal to
HIGH.
LED should be ON if
WL559E is
connected to
Router and RSSI
value is greater
than or equal to
MID.
LED should be
blinking if WL559E
is NOT connected
to any Router. LED
should be ON if
WL559E is
connected to
Router and RSSI
value is greater
than or equal to
LOW.
LED should be ON
during boot up. After
fully bootup, LED will
OFF.
LED should be
OFF while
WL559E is
booting up.
LED should be OFF
while WL559E is
booting up.
LED should be OFF
while WL559E is
booting up.
LED should be
blinking for 2 mins
once WPS button is
pressed. LED should
stop blinking and ON
for 5 secs when WPS
authentication is
successful. Then LED
should be OFF.
LED should be
OFF while
WL559E is doing
WPS
authentication.
LED should be OFF
while WL559E is
doing WPS
authentication.
LED should be OFF
while WL559E is
doing WPS
authentication.
LED should be OFF if
WL559E is connected
to Router.