User's Manual

User Manual
Page 6 of 43
Aztech WL559E RSSI LED BEHAVIOUR
The WL559E provides for a Wireless Received Signal Strength Indicator
The WL559E provides for a Wireless Received Signal Strength Indicator The WL559E provides for a Wireless Received Signal Strength Indicator
The WL559E provides for a Wireless Received Signal Strength Indicator
(RSSI), which is a combination of 3 LEDs
(RSSI), which is a combination of 3 LEDs (RSSI), which is a combination of 3 LEDs
(RSSI), which is a combination of 3 LEDs on the front panel, to
on the front panel, to on the front panel, to
on the front panel, to
allow you to determine how strong t
allow you to determine how strong tallow you to determine how strong t
allow you to determine how strong the wireless signal is from your
he wireless signal is from your he wireless signal is from your
he wireless signal is from your
router
routerrouter
router or access point
or access pointor access point
or access point to your WL559E
to your WL559Eto your WL559E
to your WL559E.
..
.
The following table gives an overview on how the three LEDs on the
The following table gives an overview on how the three LEDs on the The following table gives an overview on how the three LEDs on the
The following table gives an overview on how the three LEDs on the
front panel of the WL559E behave.
front panel of the WL559E behave.front panel of the WL559E behave.
front panel of the WL559E behave.
LED CO
LOR/BEHAVIOUR
LED 1 LED 2 LED 3 LED 3
MODE
GREEN
GREEN
GREEN
ORANGE
Wireless
Repeater
LED should be
ON if WL559E is
connected to
Router and RSSI
value is equal to
HIGH.
LED should be ON if
WL559E is
connected to
Router and RSSI
value is greater
than or equal to
MID.
LED should be
blinking if WL559E
is NOT connected
to any Router. LED
should be ON if
WL559E is
connected to
Router and RSSI
value is greater
than or equal to
LOW.
LED should b
e ON
during boot up. After
full boot up, LED will
no longer be Orange
It will switch to
GREEN..
LED should be
OFF while
WL559E is
booting up.
LED should be OFF
while WL559E is
booting up.
LED should be OFF
while WL559E is
booting up.
LED should be
blinking for 2 mins
once WPS button is
pressed. LED should
stop blinking and ON
for 5 secs when WPS
authentication is
successful. Then LED
should be OFF.
LED should be
OFF while
WL559E is doing
WPS
authentication.
LED should be OFF
while WL559E is
doing WPS
authentication.
LED should be OFF
while WL559E is
doing WPS
authentication.
LED should be OFF if
WL559E is connected
to Router.