Operating instructions

8 OI/ADS430–EN Rev. A | Aztec ADS430 | Optical dissolved oxygen probe
5Sensor setup
1. Connect the ADS430 probe to the transmitter’s EZLink
connector – see transmitter Operating instructions
OI/AWT440-EN.
2. At the AWT440 transmitter, press the key to display the
Operator Page menu, then select Enter Configuration to
display the Access Level page.
Use the key to select the Advanced menu item and
press the key (below the Select prompt).
If the Sensor Setup menu is not displayed use the /
keys to scroll to it:
Press the key (below the Select prompt).
The Sensor Setup page is displayed:
3. Ensure S1 :RDO is highlighted and press the key (below
the Select prompt).
The S1 :RDO menu page is displayed:
4. Proceed with sensor setup – see Section 6.1, page 11
for parameter options.
IMPORTANT (NOTE)
Perform this procedure on existing probe(s) only.
Probes are setup / configured individually. If installing a
new / replacement probe, see Section 4, page 7.
Exit Select
Menu
Sensor Setup
1
2
3
Sensor Setup
S1 :RDO
Back Select
Salinity Units
Pressure Units
1
2
3
S1 :RDO
Tag
PV Type
Units
Range High
Range Low
Filter Type
Back
Select