Operating instructions

4 OI/ADS430–EN Rev. A | Aztec ADS430 | Optical dissolved oxygen probe
2 System overview
ADS430 probe components are shown in Fig. 2.1:
Fig. 2.1 ADS430 probe components
A
D
S
4
3
0
x
x
x
x
x
x
Probe serial
number
Temperature
sensor
Item Feature
A
EZLink digital sensor connector
B
Shroud
C
Sensor cap (supplied unfitted in sealed factory-supplied
container)
Note. the sensor cap serial number is programmed
on the memory chip inside the cap.
D
Probe body (including temperature sensor)
E
10 m (39.3 ft.) fixed cable
Note. The probe serial number is printed on
a label at the plug end of the fixed cable.
For extension cables (including twist-lock connector) –
see Section 9.2, page 19.
F
Calibration chamber
G
Calibration chamber storage cap
H
Calibration chamber vented calibration cap
I
Sponge wafer
Table 2.1 Probe – component descriptions