User Manual

MAINTENANCE
ZII Bolt Assembly
Lift the top cocking knob (silver knob on top of the bolt) and slide out the bolt assembly
from the ZII body.
Use a cotton swab and/or microfiber cloth to clean the paint, grease, and debris from
the surface of the bolt.
Apply a thin layer of Azodin lube to the bolt assembly.
Reinsert bolt and lock the bolt pin into the designated slot on the Feather Striker.
TROUBLESHOOTING
WARNING: Always remove the loader, the air tank, and all paintballs from the marker
before disassembly.
RECOCKING ISSUES
Need Lubrication (Dow 33 based or AZ Team Lube) on the Striker O-Ring (R011).
Striker O-Ring is damaged or missing. Replace with correct O-Ring (R011).
The pressure in the tank is low and needs to be refilled.
Check the setting on the ZeRO-D System and inline Regulator.
Check, clean, and disassemble rear internals.
AIR LEAKS
Air leaks down the barrel and/or from inside the marker. Check for wear or damage on the
following parts: Front Valve O-Ring (R012), Cup Seal (Z012), and Valve face where the Cup
Seal makes contact.
Air leaks from body and out of the frame. Check the Front Valve O-Ring (R012) and check
the orientation of the valve. The opening on the side of the valve should be facing up.
Contact [e-mail] for more information or for technical assistance.
MAINTENANCE
ZeRO-D System
To remove the ZeRO-D system, firmly grip the ZeRO-D System and turn counterclockwise.
Check to see that the ZeRO-D Cup Seal and the ZeRO-D Cup Seal Stem are tight and
check for damage.
Apply Azodin Lubricant or a Dow 33 base lube to the end of ZeRO-D Cup Seal (Z012)
that enters the ZeRO-D Housing (Z041). Do NOT apply lube to the face of the Cup Seal
that makes contact with the valve, this will cause leaks or recocking issues.
DO NOT USE OIL.