User Manual

VELOCITY ADJUSTMENT
To increase your velocity FPS (Feet Per Second), use the allen wrench to turn the
Velocity Adjuster (P023) clockwise.
To decrease your velocity FPS (Feet Per Second), use the allen wrench to turn the
Velocity Adjuster (P023) counterclockwise.
CLOCKWISE
INCREASE VELOCITY
COUNTERCLOCKWISE
DECREASE VELOCITY
REGULATOR ADJUSTMENT
To increase the input pressure, use the allen wrench to turn the RockSteady Seat (P086)
counterclockwise.
To decrease the input pressure, use the allen wrench to turn the RockSteady Seat (P086)
clockwise.
NOTE: Contact [e-mail] for more information on tuning the ZII.
Always use Velocity Adjuster (P023) to increse velocity first then increase input pressure.
RESET THE REGULATOR TO FACTORY PRESSURE
1. Please remove air source and clear the air stored in the marker.
2. Turn the Rocksteady Seat clockwise till it stops (DO NOT FORCE IT PAST THE
STOP POINT).
3. Turn the RockSteady Seat counterclockwise two and half turns.
CLOCKWISE
DECREASE PRESSURE
AND VELOCITY
COUNTERCLOCKWISE
INCREASE PRESSURE AND VELOCITY
TRIGGER ADJUSTMENT
There are four adjustment points on the Trigger - Magnet Strength Screw, Micro Switch
Activation Screw, Front Stop Activation Screw and Rear Stop Trigger Screw.
1: Magnet Strength Screw
The Magnet Strength Screw adjusts the amount of force
that returns trigger to it's resting position. Turn the Magnet
Strength Screw clockwise to increase the force;
counterclcokwise to decrease the force.
NOTE: To prevent breaking the magnet, do not turn the
Magnet Strength Screw too deep.
2: Front Stop Trigger Screw:
Turn the screw clockwise to reduce the travel distance; turn the screw counterclockwise to
increase the travel distance.
2
1
ZeRO-D SYSTEM ADJUSTMENT
1: Insert 3 mm allen wrench into the ZeRO-D Adjustment Screw (Z001).
2: Turning the ZeRO-D Adjustment Screw clockwise will increase the ZeRO-D spring tension and
decrease valve timing.
increase valve timing.
3. Turning the ZeRO-D Adjustment Screw counterclockwise will decrease the ZeRO-D spring and
NOTE: Increasing the valve timing will decrease air efficiency, but will also decrease
the amount of mechanical recoil experienced.
RESET ZeRO-D SYSTEM TO FACTORY SETTINGS
Unscrew/Screw the ZeRO-D Adjustment Screw (Z011) to be flush with the ZeRO-D Housing (Z041).
Turn the ZeRO-D Adjustment Screw (Z011) clockwise 2 full turns.
If there is a C-Clip, turn the ZeRO-D Adjustment Screw (Z011) counterclockwise till it meets
the C-Clip.