User Manual

BATTERY LEVEL INDICATOR
The Battery Level Indicator is used to show the current charge of
the battery in the ZII. When the battery is full, the indicator
indicator will start to flash.
will display. As the battery empties, the battery
TOURNAMENT LOCK
Tournament Lock prevents the user from making changes to the marker parameters
without the need for tools.
To enable tournament lock, push the switch on the circuit board. (Fig 3A)
When the lock is enabled, the lock indictor will show a
closed pad lock, then user can access “Display Data”
(Display Data can only be accessed while the board is in lock mode).
When the lock is disabled, the lock indictor will show an open padlock .
User can gain access “Edit Fire Mode” & “Edit Parameter”.
Fig 3A
FIRE MODES
The PSP and the Millennium follow the rules of the respective tournament series.
Fire Mode 1: SEMI
Fire Mode 2: PSP
Fire Mode 3: Millennium
Fire Mode 4: AUTO
Fire Mode 5: Burst
Fire Mode 6: Response
Fire Mode 7: Breakout Mode -> SEMI
Fire Mode 8: SEMI
Fire Mode 9: Breakout Mode -> RAMP
Fire Mode 10: Breakout Mode -> RESPONSE
Fire Mode 11: Breakout Mode -> BURST
Fire Mode 12: AUTO
Fire Mode 13: BURST
Fire Mode 14: RESPONSE
Fire Mode 15: SEMI
Fire Mode 16: SEMI
CHANGING FIRE MODES
To change the Fire Mode value, press the bottom or pull the trigger. To save the current
selection, press the top button once. Scroll down to the “back..” selection to return to the
main menu. From there you can exit and save.
NOTE: The Zen OLED will remember the last fire mode setting used.
Break Out Mode Explained:
Break Out Mode is applied to the first trigger pull which will be full auto (BPS determined
by fire mode value). The first trigger pull only counts after the marker is turned on. You
will need to turn off the marker and turn it back on to use Break Out Mode again.
The second trigger pull will not be full auto, but will be the designated mode selected during
programming.
To change the desired fire mode after B.O. (Break Out) Mode, go to your selected fire mode
and choose fire mode parameter “8. BREAKOUT MODE”. From you can select the desired
fire mode that will be active after break out.
Break Out Mode only Valid on Values: 7, 9, 10, 11.
Example of Fire Mode 7:
First pull will be Full Auto at 12.0 BPS.
After releasing the trigger, the mode will now default to Mode 1 - Semi.
The second pull and each subsequent pull will now be semi auto at 20 BPS.
If you change the value under “8. BREAKOUT MODE” to 2 instead of 1.
First pull will be Full Auto at 12.0 BPS.
After releasing the trigger the mode will now default to Mode 2 - PSP.
The second pull and each subsequent pull will now be PSP 12.5 BPS.