User Manual

QUICK SET UP
CAUTION: Make sure the marker is in the SAFE mode and always place a
barrel blocking device on the marker's barrel when not in use.
Fig 1A
PRESS TOP BUTTON
TO TURN ON YOUR ZII
USING THE ZEN OLED
POWER ON THE ZEN OLED
POWER OFF THE ZEN OLED
Push and hold the top button until the display show "POWER OFF".
Release the top button to turn off the ZII marker.
ZEN OLED DISPLAY
1. Battery Indicator
2. Electronic Safety - Safety On
3. Tournament Lock - Disable
4. Display Data - Eye On Rate of Fire (ROF)
5. Eye Sensor - Eye On and Safety Off
6. Eye Sensor - Eye Off and Safety Off
7. Tournamemt Lock - Enable
1
5
6
3
7
4
2
ELECTRONIC SAFE
SAFETY ON SAFETY OFF
1) Screw on the barrel of the marker to the body.
2) Place the barrel blocking device at the end of marker’s
barrel.
3) Unscrew the grip screws on the left side of the marker
and remove the left grip panel. Then plug in a name brand 9V
battery to the battery harness. (PG. 10)
4) Install a HPA Tank.
5) Put on your Paintball Mask/Goggle and pull the top
cocking pin to the cocked position.
6) Screw in the front knob on the On/Off ASA to pressure
the marker.
7) Remove Barrel Blocking Device from the marker.
8) Turn on the marker by pressing the top button once (Fig 1A).
9) Turn off the electronic safety by pressing the lower button once.
10) Your marker is now ready to fire. Aim and pull the trigger to shoot.
Push and hold the top button to switch on the Zen OLED.
To turn on the Electronic Safety, press the lower button once and display will read “SAFE”.
To turn off Electronic Safety, press lower button once and the indicator will change to
indicating eye sensor system is ON (EYES ON).