User Manual

CLEANING AND DISASSEMBLE REAR INTERNALS
1. Lift upward on the Top Cocking Knob at the rear of
Delrin Bolt. This will let the Silence Bolt (PP042) slide
out from the rear of the receiver.
2. Turn the End Cap (A051) counterclockwise. This will
let the End Cap and the marker’s internals to slide out
from the rear of the receiver. Remember to place the
marker in the de-cock position and place light
pressure behind the End Cap during the removal of
the End Cap, this way will prevent the internals to
spring out.
3. Slide the KP Striker (PP021) out of the rear of the
receiver.
4. Once all the internal parts are removed, use a
squeegee to clean the inside of the receiver and use a
towel to clean the dirt or paint of Silence Bolt.
REASSEMBLE REAR INTERNALS
1. Insert the KP Striker (PP021) thru the rear of the
receiver with the Knob facing towards the front of
the marker and with the Groove on the KP striker
facing upright. While inserting the KP striker ,
apply pressure behind the KP striker and at the
same time pull the Trigger to let KP Striker enter the
rear chamber of the receiver.
2. Insert the KP Striker Spring (P025).
3. Insert the End Cap (A051) with the Velocity Adjuster
(P023) Thru the Feather Bumper and KP Striker
Spring.
4. Turn the End Cap (A051) colckwise to tighten it and
hold the internals in place.
5. Insert the Silence Bolt (PP042) thru the rear of
the receiver. Press downward on the Top Cocking
Knob (At the rear of Bolt Assembly) to connect and
enter the hole of KP Striker to fasten with the
KP Striker. Use a small tool such as allen wrench
to align the hole of the KP Striker.
CLEANING AND DISASSEMBLE KAOS PUMP KIT
1. Unscrew the Retaining Screw (S031) on the KP Handle
(AP001). This will let the KP Handle slide out from the
KP Stabilizing Rod (PP004).
2. Remove the KP Handle, use a towel to clean the dirt
or paint of KP Stablizing Rod. Apply 1-2 drops of
paintball gun oil at both of the AZ O-Ring (R013).
REASSEMBLE KAOS PUMP KIT
1.Install the KP Handle onto KP Stablizing Rod and
KP Arm.
2.Screw the KP Screw back into the KP Handle to
fasten it.
TROUBLESHOOTING
WARNING: Always remove all paintballs, loader and air tank
before disassembling the marker.
RECOCKING ISSUES
The pressure in the tank is too low and needed to be
relled.
Dirt or broken paintball shell fragments in the receiver.
Check, cleaning, and disassemble rear internals.
AIR LEAKS
Air leaking from the low pressure chamber. Check Front
Valve O-Ring (R012), replace and apply 1-2 drops of
paintball gun oil at this O-Ring.
Air leaking from under the barrel is normally caused by
worn or damaged cup seal (P013). Check the guide for
removal of Cup Seal / Valve Body.
A scratch on the Valve Body will cause air leak.
Air leaking from the receiver and throughout the Grip
frame. Check Valve O-Rings and replace.