User Manual

REGULATOR ADJUSTMENT
(INCREASE & DECREASE AIR PRESSURE)
To increase the input pressure use the allen wrench to
turn the Regulator Adjustment Screw (S032)
counterclockwise.
To decrease the input pressure use the allen wrench
to turn the Regulator Adjustment Screw (S032)
clockwise.
NOTE: Regulator is preset at the factory for optimum
performance. Fine adjustment of velocity should be done
with the Velocity Adjustor (P023).
NOTE: Each quarter turn correspond to apporximate
increase or decrease of 20psi.
VELOCITY ADJUSTMENTS
(INCREASE & DECREASE VELOCITY)
WARNING: Never remove the internals of the marker
while the air tank is attached with the marker. Always
remove all paintballs, loader and air tank before
disassembling the marker.
VELOCITY ADJUSTMENTS
(INCREASE & DECREASE)
To increase your velocity FPS (Feet Per Second), use
the allen wrench to turn the Velocity Adjuster (P023)
clockwise.
To decrease your velocity FPS (Feet Per Second), use the
allen wrench to turn the Velocity Adjuster (P023)
counterclockwise.
CLOCKWISE
INCREASE
VELOCITY
COUNTERCLOCKWISE
DECREASE VELOCITY
CLOCKWISE
DECREASE VELOCITY
COUNTERCLOCKWISE
INCREASE VELOCITY
PULL THE TOP COCKING KNOB
COUNTERCLOCKWISE
THE END CAP TO LET THE
INTERNALS SLIDE OUT