User Manual

TROUBLESHOOTING
WARNING: Always remove all paintballs, loader and air tank
before disassembling the marker.
COCKING ISSUES
Need Lubrication on the KP Striker (PP021).
Need Lubrication at the KP Stabilzing
Rod (PP004).
Dirt or broken paintball shell fragments in the receiver. Check,
cleaning, and disassemble rear internals and KP KIT.
AIR LEAKS
Air leaking from the low pressure chamber. Check Front Valve O-Ring
(R012), replace and apply 1-2 drops of paintball gun oil at this O-Ring.
Air leaking from under the barrel is normally caused by worn or
damaged cup seal (PP012). Check the guide for removal of Cup
Seal / Valve Body.
A scratch on the Valve Body will cause air leak.
Air leaking from the receiver and throughout the grip frame.
Check Valve O-Rings and replace.
Air Leaking at opposite end of hose ttings:
The Female end of the hose should have a Plastic Seal Washer
(P062) installed inside the hose collar and be sure to tighten it
properly.
ZENITH SCREW
CHART SIZE: 1:1
PART NUMBER AND NAME
S011 M5 X 10L
MAIN BODY SCREW
S012 M8 X 8L
VALVE RETAINING SCREW
S014 M5 X 16L
VERTICAL ASA SCREW
S015 M3 X 3L
DETENT COVER SCREW
S016 M4 X 8L
GRIP PANEL SCREW
S019 M3 X 6L
EYE COVER SCREW
S020 M3 X 4L
SWITCH COVER SCREW
S031 M4 X 4
REGULATOR RETAINING
SCREW
S032 M12 X 8L
REGULATOR ADJUSTMENT
SCREW
S091
ON/OFF BOTTOM ASA
RETAINING SCREW
S092 1/8-27 NPT
ON/OFF BOTTOM ASA
HOSE PLUG
S093 M5 X 10L
ON/OFF BOTTOM ASA SCREW
ZENITH O-RING
CHART SIZE: 1:1
PART NUMBER AND NAME
R012
FORNT VALVE O-RING
(CLEAR)
R013
VELOCITY ADJUSTER O-RING
(BLACK)
R015
AZ O-RING
(BLACK)
R016
BARREL O-RING
(BLACK)
R017
END CAP O-RING
(BLACK)
RT001
TRIAD O-RING
(BLACK)
R031
REGULATOR PISTON O-RING
(CLEAR)
R032
REGULATOR SWIVEL
MOUNT O-RING (BLACK)
R033
INNER O-RING
(CLEAR)
R034
REGULATOR SEAL O-RING
(CLEAR)
R091
ON/OFF BOTTOM ASA O-RING
(CLEAR)