User Manual

ASSEMBLY AND CLEANING
WARNING: Never remove the internals of the marker while
the air tank is attached with the marker. Always remove all
paintballs, loader and air tank before disassembling the marker.
PULL THE TOP COCKING KNOB
COUNTERCLOCKWISE THE END CAP
TO LET THE INTERNALS SLIDE OUT
REGULATOR ADJUSTMENT
(INCREASE & DECREASE AIR PRESSURE)
To increase the input pressure use the allen wrench to turn the
Regulator Adjustment Screw (S032) counterclockwise.
To decrease the input pressure use the allen wrench to turn the
Regulator Adjustment Screw (S032) clockwise.
NOTE: Regulator is preset at the factory for optimum performance.
Fine adjustment of velocity should be done with the Velocity
Adjustor (P023) on page 9.
NOTE: Each quarter turn correspond to apporximate increase or
decrease of 20psi.
COUNTERCLOCKWISE
INCREASE VELOCITY
CLOCKWISE
DECREASE VELOCITY
CLEANING AND DISASSEMBLE REAR INTERNALS
1. Lift upward on the Top Cocking Knob at the rear of Delrin Bolt.
This will let the KP Bolt Assembly (PP041) slide out from the rear
of the receiver.
2. Turn the End Cap (A051) counterclockwise. This will let the
End Cap and the marker’s internals to slide out from the
rear of the receiver. Remember to place the marker in the
de-cock position and place light pressure behind the End Cap
during the removal of the End Cap, this way will prevent the
internals to spring out.
3. Slide the KP Striker (PP021) out of the rear of the receiver.
4. Once all the internal parts are removed, use a squeegee to clean
the inside of the receiver and use a towel to clean the dirt or
paint off Delrin Bolt. Apply 1-2 drops of paintball gun oil at the
side of the Striker regularly.
REASSEMBLE REAR INTERNALS
1. Insert the KP Striker (PP021) thru the rear of the receiver
with the tip facing towards the front of the marker and
with the hole on the KP Striker facing upright. While inserting the
KP Striker, apply pressure behind the KP Striker and at the
same time pull the Trigger to let KP Striker enter the receiver.
2. Insert the KP Bolt Assembly (PP041) thru the rear of the
receiver. Press downward on the Top Cocking Knob (At the
rear of KP Bolt Assembly) to connect with the KP Coupler
(PP006). Make sure the KP Striker is align to the KP Bolt
Assembly.
3. Insert the KP Striker Spring (P025) thru the receiver.
4. Turn the End Cap (A051) with the Velocity Adjuster (P023)
Thru the KP Striker Spring.
5. Turn the End Cap clockwise to tighten it and hold the
internals in place.
CLEANING AND DISASSEMBLE KAOS PUMP KIT
1.Unscrew the Retaining Screw (S031) on the KP Handle (AP001).
This will let the KP Handle slide out from the KP Stabilizing
Rod (PP004).
2.Remove the KP Handle, use a towel to clean the dirt or paint
of KP Stablizing Rod. Apply 1-2 drops of paintball gun oil at
both of the AZ O-Ring (R013).
REASSEMBLE KAOS PUMP KIT
1.Inatall the KP Handle onto KP Stablizing Rod and KP Arm.
2.Screw the Retaining Screw back into the KP Handle to fasten it.