User Manual

VELOCITY ADJUSTMENTS
(INCREASE & DECREASE)
To increase your velocity FPS (Feet Per Second), use the allen
wrench to turn the Velocity Adjuster (P023) clockwise.
To decrease your velocity FPS (Feet Per Second), use the allen
wrench to turn the Velocity Adjuster counterclockwise.
LED COLORS
USING THE ZEN BOARD
TO TURN ON THE BOARD: Press the Top Button once to turn on
the board. Upper LED will show Red Light (Safe Mode) and Lower
LED will show Green Light (Default setting is Semi-Auto mode)
or your previous setting (The ZEN Board will memorize last
setting of shooting mode.)
If Upper LED Light is ashing Red Light, it means battery power
status is low and the battery needs to be change. Battery power
status can be veried by press Top Button once more to conrm.
SAFF MODE: After turning on the board, press Bottom Button
once to turn off the Safe Mode and Upper LED Light will show
Green Light to indicate the Eyes are on
Press Bottom Button again to turn on the Safe Mode. Right now the
Upper LED Light will show Red Light to indicate the Safe Mode
is on.
EYES ON/OFF: When Safety is on and Upper LED Light is
showing Green Light (Eyes On). Press the Top Button once and
Upper LED Light will change to Orange Light to indicate the eyes
are off. To turn the eyes back On, Press Top Button again and
Upper LED Light will showing Green Light again to indicate the
Eyes are back on. When there is a ball break or Eyes are
malfunction, Upper LED Light will Flash Green Light. Now press
Top Button to turn off the Eyes and press Top Button again to turn
the back Eyes on to determine the problem. If the Upper LED light
still Flash Green Light, clean out the Eyes.
UPPER LED
LOWER LED
RED = SAFF MODE
GREEN = EYES ON
ORANGE = EYES OFF
FLASH RED = LOW BATTERY POWER STATUS
FALSH GREEN = EYES MALFUNCTION
GREEN = PUMP MODE
DARK BLUE = AUTO TRIGGER MODE
PURPLE = ENHANCED TRIGGER MODE
BUTTONS
TOP BUTTON
BOTTOM BOTTON
PRESS ONCE = POWER ON
PRESS AGAIN = VERIFY BATTERY POWER STATUS
PRESS AGAIN = EYES ON/OFF
PRESS AND HOLD = TURN OFF
PRESS ONCE = SAFF MODE ON/OFF
PRESS AND HOLD = ENTERS PROGRAMMING MODE
IN PROGRAMMING MODE
PRESS ONCE = CYCLE THROUGH SHOOTING MODES
PRESS AND HOLD = CONFIRM SHOOTING MODES
* ZEN Board will memorize last setting of shooting mode
COUNTERCLOCKWISE
DECREASE VELOCITY
CLOCKWISE
INCREASE
VELOCITY
PUMP MODE (EYE ON)
Marker will not re unless striker bolt is back and locked in sear.
PUMP MODE (EYE OFF)
Marker will re at anytime when trigger is depressed.
AUTO TRIGGER MODE (EYE ON)
Marker will not re unless striker bolt is back and locked in sear.
Pumping the cocking rod while holding the trigger down will result
in rapid re.
AUTO TRIGGER MODE (EYE OFF)
Marker will re at anytime when trigger is depressed.
Pumping the cocking rod while holding the trigger down will result
in rapid re. The difference is when striker bolt touches the switch,
the marker is ready to re.
ENHANCED TRIGGER MODE (EYE ON)
Marker will not re unless striker bolt is back and locked in sear.
Keep pumping the cocking rod even without holding the trigger
will result in rapid re.
ENAHNCED TRIGGER MODE (EYE OFF)
Marker will re at anytime when pumping the cocking rod.
The difference is when striler bolt touches the switch, the marker
is ready to re.