User Manual

REGULATOR ADJUSTMENT
To increase the input pressure, use the allen wrench to
turn the Rock Steady Seat (RSS2) counterclockwise.
To decrease the input pressure, use the allen wrench to
turn the Rock Steady Seat (RSS2) clockwise.
NOTE: Contact [e-mail] for more information
on tuning the KP-III.
Always use Velocity Adjustor (VA01) to increse velocity
rst then increase input pressure.
RESET THE REGULATOR TO FACTORY PRESSURE
1. Please remove air source and clear the air stored in the
marker.
2. Turn the Rocksteady Seat clockwise till it stops (DO
NOT FORCE IT PAST THE STOP POINT).
3. Turn the RockSteady Seat counterclockwise two and
half turns.
ASSEMBLY AND CLEANING
THE MARKER
WARNING: Never remove the internals of the marker
while the tank is attached to the marker. Always remove
the loader, the air tank, and all paintballs from the marker
before disassembly.
VELOCITY ADJUSTMENTS
WARNING: Do not turn the velocity adjust clockwie more
than 6 turns. This may strip the threads on
the Velocity Adjuster and End Cap.
To increase your velocity FPS (Feet Per Second), use
the allen wrench to turn the Velocity Adjuster (VA01)
clockwise.
To decrease your velocity FPS (Feet Per Second), use
the allen wrench to turn the Velocity Adjuster (VA01)
counterclockwise.
CLOCKWISE
INCREASE VELOCITY
COUNTERCLOCKWISE
DECREASE VELOCITY
CLOCKWISE
DECREASE PRESSURE
AND VELOCITY
COUNTERCLOCKWISE
INCREASE PRESSURE AND VELOCITY
1
3
2
PULL THE TOP COCKING KNOB
COUNTERCLOCKWISE THE END CAP
TO LET THE INTERNALS SLIDE OUT
Turn the End Cap Counterclockwise to access the internals