User Manual

GETTING STARTED
1. First, place the BARREL BLOCKING DEVICE over the barrel.
2. Always point your marker at a “SAFE” direction before use. To use, push the
safety button from the “PUSH SAFE” side of the grip frame. Doing this will
put the marker in a lock safe mode.
To unlock the safe mode, point the marker in the safe direction, and push the
safety button towards the “PUSH SAFE” side of the grip frame.
3. Firmly screw in the HPA / N2 air tank to the On/Off Bottom ASA (A091).
Tighten the air tank clockwise all the way in the marker’s bottom ASA.
CAUTION: Never use any hand tool to screw air tank to the bottom ASA.
4. Attach a paintball hopper/ loader to the marker’s feed neck.
6. Remove the barrel blocking device and unlock the safe mode.
CAUTION: Now the marker is LIVE, pulling the trigger will fire a paintball.
Only test your marker at the safe direction or in a proper organized paintball field.
7. Check marker’s velocity FPS (Feet Per Second).
Turning the Velocity Adjuster (P023) clockwise will increase the velocity.
Counterclockwise will decrease the velocity.
5. Turn the On/off Bottom ASA Cap (A092) clockwise to let air go into the marker.
8. After playing, take out all paintballs from the hopper.
Then detach the hopper from the marker.
CAUTION: There may be 1-2 paintballs in the breach area; take a couple more
shots in a safe direction to make sure the marker is empty of paintballs.
9. Place the barrel blocking device over the barrel and push the safety button
10. Counterclockwise the On/off Bottom ASA Cap (A092) to release air pressure
in the marker.
in the safe mode.
11. Unscrew the HPA / N2 air tanks from the marker’s bottom ASA.
CAUTION: Never use any hand tool to screw air tanks to the bottom ASA.
12. Store the marker in a paintball bag or in a safe place.
VELOCITY ADJUSTMENT
To increase your velocity FPS (Feet Per Second), use the allen wrench to turn the
Velocity Adjuster (P023) clockwise.
To decrease your velocity FPS (Feet Per Second), use the allen wrench to turn the
Velocity Adjuster (P023) counterclockwise.
CLOCKWISE
INCREASE VELOCITY
COUNTERCLOCKWISE
DECREASE VELOCITY
REGULATOR ADJUSTMENT
To increase the input pressure, use the allen wrench to turn the Rock Steady Seat (P086)
counterclockwise.
To decrease the input pressure, use the allen wrench to turn the Rock Steady Seat (P086)
clockwise.
NOTE: Contact [e-mail] for more information on tuning the KD-II.
Always use Velocity Adjuster (P023) to increse velocity first then increase input pressure.
RESET THE REGULATOR TO FACTORY PRESSURE
1. Please remove air source and clear the air stored in the marker.
2. Turn the Rocksteady Seat clockwise till it stops (DO NOT FORCE IT PAST THE
STOP POINT).
3. Turn the RockSteady Seat counterclockwise two and half turns.
CLOCKWISE
DECREASE PRESSURE
AND VELOCITY
COUNTERCLOCKWISE
INCREASE PRESSURE AND VELOCITY