User Manual

TROUBLESHOOTING
WARNING: Always remove all paintballs, loader and air
tank before disassembling the marker.
KAOS-II SCREW CHART
SIZE: 1:1
PART NUMBER AND NAME
KAOS-II SCREW CHART
SIZE: 1:1
PART NUMBER AND NAME
R010
NO.10 O-RING
(BLACK)
R014
NO.14 O-RING
(BLACK)
RR15
STRIKER O-RING
(RED)
RP15
NO.15 O-RING
(CLEAR)
R015
NO.15 O-RING
(BLACK)
M3 X 3.5L
DETENT COVER SCREW
M4 X 8L
GRIP PANEL SCREW
M4 X 9.5L
FEEDNECK LOCK SCREW TOP
M4 X 12L
FEEDNECK LOCK SCREW
M5 X 8L
FOREGRIP RETAINING SCREW
M5 X 10L
MAIN BODY SCREW
M5 X 12L
BOTTOM ASA RETAINING SCREW
M5 X 16L
VERTICAL ASA SCREW
M8 X 8L
VALVE RETAINING SCREW
Check the Striker O-ring (RR15). If the O-ring is damaged or worn
replace it with another Striker O-ring (RR15).
DO NOT USE OTHER O-RINGS for this if the Striker is dry, apply a
thin layer of Azodin lube or dow 33 based lubricant to the striker and
its O-ring.
If the Striker is dirty, replace the O-ring and wipe it down and perform
the above steps
Air leaking from the barrel area it is normally caused by worn or
damaged cup seal (CS01). Replace the Cup Seal Cap with the one
in your kit.
Other cause are related to the RP15 and R015 O-ring.
Replace the O-ring and apply a thin layer of dow 33 based
lubricant on the O-rings Make sure to keep the valve face clean.
Air leaking from the receiver and through the Grip frame.
Check The Valve Retaining screw to see if it is loose.
Air Leaking at opposite end of the hose fittings:
The Female end of the hose should have a plastic Seal Washer
(SW01) installed inside the hose collar. Be sure to tighten both
ends properly.