User Manual

VELOCITY ADJUSTMENTS
(INCREASE & DECREASE)
To increase your velocity FPS (Feet Per Second), use the allen
wrench to turn the Velocity adjuster (VA01) clockwise.
To decrease your velocity FPS (Feet Per Second), use the allen
wrench to turn the Velocity adjuster (VA01) anticlockwise.
CLEANING AND DISASSEMBLE
REAR INTERNALS
1. Pull up the pin at the rear of Delrin Bolt, but do not pull it out.
This will let the Delrin Bolt (BA01) slide out from the rear of the
receiver.
2. Twist the End Cap (EC02) counterclockwise to remove the
internal components of the marker.
(Spring, Bumper, Feather Striker)
3. Slide the Feather Striker (FS01) out of the rear of the receiver
with either your tools or you nger.
4. Once all the internal parts are removed, use a squeegee to clean
the interior and relubricate the feather striker with Azodin lube or
Dow 33 based lubricant.
REASSEMBLE THE REAR INTERNALS
1. Reinsert the Feather Striker. Make sure the Striker O-ring (RR15)
is facing the Front and the hole is facing upwards.
2. Push on the Feather Striker to apply continuous pressure and
pull Trigger until the striker clears the sear.
3. Locate the Striker hole and make sure the hole is centered and
facing upwards. Insert the Bolt Assembly (BA01) into the receiver
and align the pin with the striker hole, then push the pin down to
lock it in place.
4. Test the assembled Bolt and Striker by pushing the bolt forward.
If the bolt is in the cocked position it should not move until you
pulll the Trigger while applying pressure like in step 2.
4a. If it is not in the cocked position, pull it into the cocked position
to check if they are assembled correctly and redo the begining of
step 4.
5. Reinsert the Bumper marking sure it is not inserted at an angle
and that all sides are touching the walls of the receiver.
6. Reinsert the spring through the bumper and screw on the end cap
Assembly. Make sure the velocity adjustor goes through the spring
And bumper.
ASSEMBLY AND CLEANING
WARNING: Never remove the internals of the marker while
the air tank is attached with the marker. Always remove all
paintballs, loader and air tank before disassembling the marker.