User's Manual

Table Of Contents

REASSEMBLE REAR INTERNALS

1. Insert the Feather Striker (P021) thru the rear of the receiver

with the O-Ring facing towards the front of the marker and

with the hole on the Feather Striker facing upright. While

inserting the Feather Striker, apply pressure behind the Feather

Striker and at the same time pull the Trigger to let Feather

Striker enter the rear chamber of the receiver.

2. Insert the Feather Bumper (P024) thru the receiver and insert

the Feather Spring (P022) thru the Feather Bumper.

3. Insert the End Cap (A051) with the Velocity Adjuster (P023)

Thru the Feather Bumper and Feather Spring.

4. Turn the End Cap (A051) clockwise to tighten it and hold the

internals in place.

5. Insert the Bolt Assembly (P041) thru the rear of the receiver.

Press downward on the Top Cocking Knob (At the rear of Bolt

Assembly) to connect and enter the hole of Feather Striker to

fasten with the Feather Striker. Use a small tool such as allen

wrench to align the hole of the Feather Striker.