User Manual

DISASSEMBLING AND CLEANING THE READ
INTERNALS
1. Lift the Top Cocking Knob (Silver pin at the top of the
Delrin Bolt (BA02)) and slide the bolt out of the
receiver.
2. Turn the End Cap (EC02) counter clockwise and
remove it from the marker.
3. Remove the bumper (FB5), striker spring (FSP1), and
Feather Striker (FS01).
4. Clean all internals with a towel and squeegee the
inside of the receiver. Apply Azodin team lube or a
dow 33 grease to the striker.
REASSEMBLING THE REAR INTERNALS
1. Insert the Feather Striker (FS01) with the red o-ring
facing the front of the marker and the hole facing
upwards.
2. Apply pressure behind the Feather Striker and pull the
trigger. The Feather Striker will pass the trigger sear.
Repeat if the striker catchs on the sear again.
3. Insert the Feather Bumper (FB01) and the the Feather
Spring (FSP1) through the Bumper.
4. Insert the Bolt Assembly (BA02). Align the silver
pin with the hole at the top of the striker. Push the pin
downwards until it seats inside of the striker.
5. Insert the End Cap (EC02) and turn it clockwise to
thread it into the body.
TROUBLESHOOTING
WARNING: Always remove all paintballs, the loader, and the
air tank from the marker before disassebly.
RECOCKING ISSUES
Striker O-ring (R015) needs to be lubricated.
Striker O-ring (R015) is damaged or missing and needs to
be replaced.
The pressure in the tank is too low and needs to be
relled.
Bolt and internals need to be cleaned. Perform the steps
outlined in the basic maintenance section on page 10-11.
The regulator has been incorrectly adjusted. Reset
regulator back to factory settings. Contact Azodin for
settings and directions.
AIR LEAKS
From the Z2H1: Check the Front Valve O-ring (R015) and
Inner Zero O-ring (RV10). Replace if needed.
Down the Barrel: Check the Cup Seal (ZCS2), Front Valve
O-ring (RP15), and Vavle (MFV1). Scratches, damage, dirt,
oil, grease, and/or paint on these areas will cause leaks.
Between the trigger frame and receiver: Check the o-rings
on the valve for damage and replace if needed. Determine
the valve's orientation and correct if needed.
For a thorough breakdown of the marker, please visit the
Azodin website or our Youtube channel AzodinPB.
EVO-II SCREW
CHART SIZE: 1:1
PART NUMBER AND NAME
M4 X 4L
RETAINING SCREW
TRIGGER SCREW
M4 X 6L
TRIGGER SCREW
M4 X 8L
GRIP PANNEL SCREW
M4 X 8L
EYE COVER SCREW
M5 X 10L
MAIN BODY SCREW
M5 X 12L
VERTICAL ASA SCREW
M5 X 12L
ON/OFF BOTTOM ASA
SCREW
M8 X 8L
VALVE RETAINING SCREW
BARS
ON/OFF BOTTOM ASA
RETAINING SCREW
BAHP
ON/OFF BOTTOM ASA
HOSE PLUG